Will Just Changing Out Windings Fix A Motor
i hard drive ii epitome by Graham Lumsden from Fotolia.com
When a hard drive dies, it tin can be nerve-wracking, particularly if your information was non backed up. This trouble can occur for a multitude of reasons: Mayhap you lot recently plugged in new hardware or installed software and didn't follow the directions properly, or mayhap the drive has been dropped, bent or otherwise physically damaged in some way. Unfortunately, there's no surefire style to fix a hard bulldoze or its motor, but there are many techniques you tin try with fingers crossed before you transport off the drive for costly data recovery.
Extract the hard drive carefully from your figurer. Techniques to exercise this will vary from computer to computer. In social club to determine the source of the problem, you will need to inspect diverse pieces and parts. After each corrective step, attempt to boot the difficult bulldoze normally and notice changes in behavior.
Examine the exterior of the bulldoze for any obvious damage, such as bent parts or scorch marks. These could indicate improper installation, power supply issues, or a dysfunctional connection to the motherboard.
Try freezing the hard disk overnight. This technique has been met with varying success--it will non ever work. If information technology does revive the difficult drive, information technology volition only be for a short fourth dimension, so use the opportunity to transfer all data off of it and onto a new, secure external hard drive.
Rap lightly on the edge of the hard drive motor with your knuckle. Practice not knock hard enough to harm the drive; just rap lightly to run into whether this will leap-start the drive into spinning again.
Remove the screws property the controller board to the back of the drive to expose the board. If there is an indication of power when y'all outset beginning upwardly the hard drive, such every bit the spindle moving momentarily, you may have an event with one of the pins. Use masking tape to comprehend each pin individually (preventing connection to the motherboard) until y'all find the i that, when covered, allows the drive to spin.
Replace the pin with ane of identical size and shape. The best place to discover a spare pin is from another hard drive of the same make and model. If y'all don't have i available, bank check your other calculator peripherals or contact a computer repair business for spare parts.
Perform a terminal-ditch at-abode set by dropping the drive from about 5 to 8 inches in a higher place a surface to try to "jog" it back into functioning. Every bit with freezing, this is a technique that will not always piece of work, and it should be used with the awareness that it may in fact damage the disk further. Yet, information technology may restart the drive long enough to allow for data recovery.
Contact professionals. In extreme cases, a bad head may exist the trouble. Information technology is possible to replace this with a working head from some other of the aforementioned model hard drive, but it requires a lot of finesse and careful piece of work, equally heads are extremely sensitive pieces of hardware. It is generally recommended to go out this work to professionals at a figurer repair shop.
Will Just Changing Out Windings Fix A Motor,
Source: https://itstillworks.com/fix-hard-drive-motor-7621870.html
Posted by: wilsonceshounce72.blogspot.com
0 Response to "Will Just Changing Out Windings Fix A Motor"
Post a Comment